HDBaseT installation solutions

Konnect design click
HDMI – HDBaseT

Wall connection system for standard socket frames

Wall installation system for an elegant integration of HDBaseT into standard double-gang socket frames of German resp. European manufacturers.

Adapter frames for cutout sizes 50 x 50, 54 x 54 and 55 x 55 mm are included in the package.

Our HDBaseT system supports PoC, i. e. only one power supply is required for each set consisting of sender and receiver, no matter if the sender or receiver is connected with the power supply.

You can choose between a low-priced mobile power supply with a plug or a practical in-wall solution.

  • HDMI transmission via HDBaseT up to 70 m
  • Additional Cat-6 GenderChanger for network (separate wiring required)
  • Supports HDCP, EDID and HDMI 1.4, 3D & 4K x 2K
  • PoC - only one power supply for sender and receiver 
Konnect design click
HDMI - HDBaseT receiver
as supplied in package
Konnect design click
HDMI - HDBaseT transmitter
installed in double-gang socket frames

HDMI - HDBaseT Kit
GB2/GB3

Transmitter for floor boxes

The HDBaseT transmitters are also offered for the use in floor boxes in two different sizes - GB2 and GB3.

In addition the module holders can be fitted with 2 full-size resp. 4 half-size adapter plates of the Konnect alu 50 programme.

Module holder GB2 with HDMI - HDBaseT transmitter
Module holder GB3 with HDMI - HDBaseT transmitter

Konnect Design Multishare 21 HDBaseT

The Konnect design click Multishare 21 wall-plate is a compact multi-format HDBaseT transmitter for 2-gang switch boxes

It allows to transmit HDMI, VGA and audio signals as well as control commands via a single CAT-6/7 cable up to a distance of 70 m to a compatible HDBaseT receiver without signal loss. Any connected active signal source is detected and selected automatically or can be switched via a button press.

Konnect design Multishare 21 HDBaseT can also power up/down the connected display device via RS232 upon detection of an active input signal. The wall-plate can be powered locally or from the remote receiver side.

Recommended HDBaseT Receiver: Kindermann 7488 000 066

  • Inputs: 1 HDMI, 1 VGA / 3,5 mm audio
  • Output: HDBaseT
  • Transmission distance: up to 70 m at Full HD/WUXGA resolution or 40 m at 4K@30Hz via Cat-6/7 installation cable
  • Supports HDMI 1.4a, 4Kx2K (30 Hz)
  • HDCP 1.4 compliant, 3D compatible
  • Supports VGA signals up to WUXGA (1920 x 1200@60 Hz)
  • Advanced EDID Management: Passthrough, predefined EDID, manually captured EDID, (for both VGA and HDMI)
  • Control options: automatic source selection, front button, RS232, contact closure with LED feedback
  • Power supply either via local PSU 24 VDC / 1A (optional) or via PoC/PoH using a compatible receiver
  • Dimensions: 103 x 52 x 40 mm (WxHxD)